62 Configuring standard security features
Sample mibCapability configuration:
Sample systemGroup configuration (default):
Using legacy commands for SNMPv1
Use the snmpConfig command to configure the SNMPv1 agent and traps (see ”Using the snmpConfig
command” on page 59). However, if necessary for backward compatibility, you can choose to use legacy
commands.
switch:admin> snmpconfig --show mibCapability
FA-MIB: YES
FICON-MIB: YES
HA-MIB: YES
SW-TRAP: YES
swFCPortScn: YES
swEventTrap: YES
swFabricWatchTrap: YES
swTrackChangesTrap: NO
FA-TRAP: YES
connUnitStatusChange: YES
connUnitEventTrap: NO
connUnitSensorStatusChange: YES
connUnitPortStatusChange: YES
SW-EXTTRAP: NO
FICON-TRAP: NO
HA-TRAP: YES
fruStatusChanged: YES
cpStatusChanged: YES
fruHistoryTrap: NO
switch:admin> snmpconfig --default systemGroup
*****
This command will reset the agent's system group configuration back to
factory default
*****
sysDescr = Fibre Channel Switch
sysLocation = End User Premise
sysContact = Field Support
authTraps = 0 (OFF)
*****
Are you sure? (yes, y, no, n): [no] y
To Next Page
Loading...
