3–38 Technical Reference Guide
Installing or Replacing Parts
Replace the Power Supply
Using the figure on page 3-34 as a guide:
1. Before inserting the power supply, be sure to re-connect the two processor power module
cables (from the power supply) to the power modules (on the system board).
2. Align the tabs on the power supply with the mounting holes on the system chassis.
3. Insert the new power supply into the system chassis. Push the power supply up and slide it
towards the back of the chassis until it snaps into place.
4. Connect the remaining power supply power cables to all system components, including the
hard drive(s), optical drive(s) and system board. Make sure the cables are routed properly, so
they do not block the airflow guide or interfere with the heatsinks on the processors.
Replace the Airflow Guide
Using the figure on page 3-38 as a guide:
1. Insert the airflow guide into the system and press until it snaps into place.
2. Plug the memory fan connector into the system board.
Replace the System Access Panel
Using the figure on page 3-8 as a guide:
1. Replace the system access panel.
2. Plug in the power cable and start the system to verify that it boots properly with the new
processor.
To Next Page
Loading...
Need help?
General
