HP Compaq Pro 6300 Series Microtower

To Next Page

To Previous Page

7. Pull the assembly toward the rear of the unit (2), and then lift it out of the chassis.

Figure 7-29 Removing the front fan

To install the front fan, reverse the removal procedure. Be sure to orient the air flow into the unit.

Front Fan Assembly 121

Main Page

Default Chapter3
- About this Book3
- Table of Contents4
1 Product Features10
2 Activating and Customizing the Software16
- Activating and Customizing the Software in Windows 716
- Activating and Customizing the Software in Windows 817
3 Computer Setup (F10) Utility19
- Computer Setup (F10) Utilities19
- Recovering the Configuration Settings33
4 Illustrated Parts Catalog34
- Microtower (MT) Chassis Spare Parts34
- Small Form Factor (SFF) Chassis Spare Parts44
5 Routine Care, SATA Drive Guidelines, and Disassembly Preparation54
6 Removal and Replacement Procedures Microtower (MT) Chassis63
7 Removal and Replacement Procedures Small Form Factor (SFF) Chassis103
8 Troubleshooting Without Diagnostics145
9 POST Error Messages186
- POST Numeric Codes and Text Messages187
- Interpreting POST Diagnostic Front Panel Leds and Audible Codes195
10 Password Security and Resetting CMOS199
- Resetting the Password Jumper200
- Clearing and Resetting the CMOS201
11 HP PC Hardware Diagnostics203
12 Backup and Recovery205
- Restoring and Recovering in Windows 7205
  - System Restore205
  - System Recovery205
- Backup and Recovery in Windows 8210
  - Backing up Your Information210
  - Performing a System Recovery211
Appendix A Battery Replacement213
Appendix B Removing and Replacing a Removable 3.5-Inch SATA Hard Drive216
Appendix C Unlocking the Smart Cover Lock221
- Smart Cover Failsafe Key221
- Using the Smart Cover Failsafe Key to Remove the Smart Cover Lock222
Appendix D Power Cord Set Requirements224
Appendix E Specifications226
- MT Specifications226
- SFF Specifications228
Index229

HP Compaq Pro 6300 Series Microtower

Table of Contents

Related product manuals