EasyManuals Logo

HP Elite 7000 - Microtower PC Maintenance And Service Guide

HP Elite 7000 - Microtower PC
128 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #59 background imageLoading...
Page #59 background image
Removing an Internal 3.5-inch Hard Drive
NOTE: Before you remove the old hard drive, be sure to back up the data from the old hard drive so
that you can transfer the data to the new hard drive. Also, if you are replacing the primary hard drive,
make sure you have created a Recovery Disc Set to restore the operating system, software drivers, and
any software applications that were preinstalled on the computer. If you do not have this CD set,
select Start > HP Backup and Recovery and create it now.
1. Prepare the computer for disassembly (Preparation for Disassembly on page 29).
2. Remove the access panel (
Access Panel on page 30).
3. Remove the two screws that secure the hard drive cage to the chassis.
Figure 7-24 Removing the Hard Drive Cage Screws
4. Push down the latch on the side of the hard drive cage (1), then slide the hard drive cage away
from the bottom of the chassis (2) as shown below.
Figure 7-25 Releasing the Hard Drive Cage
Drives 51

Table of Contents

Other manuals for HP Elite 7000 - Microtower PC

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the HP Elite 7000 - Microtower PC and is the answer not in the manual?

HP Elite 7000 - Microtower PC Specifications

General IconGeneral
BrandHP
ModelElite 7000 - Microtower PC
CategoryDesktop
LanguageEnglish

Related product manuals