3. Remove the audio jack (3) from the computer.
Reverse this procedure to install the audio jack.
Connector board cable
To remove the connector board cable, use this procedure and illustration.
NOTE: The connector board cable is included in the Cable Kit, spare part number N09040-001.
Before removing the connector board cable, follow these steps:
1. Prepare the computer for disassembly (see Preparation for disassembly on page 45).
2. Remove the bottom cover (see Bottom cover on page 45).
3. Disconnect the battery cable from the system board (see Battery on page 47).
Remove the connector board cable:
1. Release the ZIF connector (1) to which the connector board cable is connected, and then disconnect the
cable from the system board.
2. Release the ZIF connector (2) to which the connector board cable is connected, and then disconnect the
cable from the connector board.
Connector board cable 57
To Next Page
Loading...
