2. Detach the NFC module (2) from the top cover/keyboard. (The NFC module is attached to the top cover/
keyboard with double-sided adhesive.)
3. Remove the NFC module.
Reverse this procedure to install theNFC module.
Touchpad cable
To remove the touchpad cable, use this procedure and illustration.
NOTE: The touchpad cable is included in the Cable Kit, spare part number N09040-001.
Before removing thetouchpad cable, follow these steps:
1. Prepare the computer for disassembly (see Preparation for disassembly on page 45).
2. Remove the bottom cover (see Bottom cover on page 45).
3. Remove the battery (see Battery on page 47).
Remove the touchpad cable:
1. Release the ZIF connector (1) to which the touchpad cable is connected, and then disconnect the touchpad
cable from the system board.
2. Release the ZIF connector (2) to which the touchpad cable is connected, and then disconnect the touchpad
cable from the touchpad.
82
Chapter 5Removal and replacement procedures for authorized service provider parts
To Next Page
Loading...
