HP EliteBook 840 G9 - Solid-State Drive

To protect a memory module after removal, place it in an electrostatic-safe container.
To install a memory module:
1. Align the notched edge of the module with the tab in the slot (1), and then press the module into the slot at
an angle until it is seated (2).
2. Press down on the module until the side retention clips snap into place (3).
Solid-state drive
To remove the M.2 solid-state drive, use this procedure and illustration.
Table 5-7
Solid-state drive descriptions and part numbers
Description Spare part number
2 TB, M.2 2280, PCIe-4×4, ZTurbo solid-state drive with TLC M52027-001
1 TB, 2280, PCIe-4×4, NVMe solid-state drive with TLC M16560-001
512 GB, 2280, PCIe-4×4, NVMe solid-state drive with TLC M17436-001
512 GB, M.2 2280, PCIe, NVMe, value solid-state drive with TLC L85364-001
512 GB, M.2 2280, PCIe-4×4, SED solid-state drive with TLC M52031-001
256 GB, M.2 2280, PCIe-4×4, ZTurbo solid-state drive with TLC M52025-001
256 GB, M.2 2280, PCIe-4×4, SED solid-state drive with TLC M52029-001
Solid-state drive shield: Included in the Bracket Kit, spare part number N09030-001. L85354-001
Before removing the solid-state drive, follow these steps:
1. Prepare the computer for disassembly (see Preparation for disassembly on page 45).
54
Chapter 5Removal and replacement procedures for authorized service provider parts