HP EliteBook 840 G9 - Page 84

Table 5-13 Fingerprint reader description and part number
Description Spare part number
Fingerprint reader
NOTE: The ngerprint reader spare part kit does not include the ngerprint reader bracket or ngerprint
reader cable. The ngerprint reader bracket is included in the Bracket Kit, spare part number N09030-001. The
ngerprint reader cable is included in the Cable Kit, spare part number N09040-001.
N08532-001
Before removing the ngerprint reader, follow these steps:
1. Prepare the computer for disassembly (see Preparation for disassembly on page 45).
2. Remove the bottom cover (see Bottom cover on page 45).
3. Remove the battery (see Battery on page 47).
4. Remove the right speaker (see Speakers on page 51).
Remove the ngerprint reader:
1. Remove the Phillips M2.0 × 2.5 broad head screw (1) that secures the ngerprint reader and bracket to the
computer.
2. Remove the ngerprint reader bracket (2).
The ngerprint reader bracket is included in the Bracket Kit, spare part number N09030-001.
3. Release the ZIF connector (3) to which the ngerprint reader cable is connected, and then disconnect the
ngerprint reader cable from the system board.
4. Detach the ngerprint reader cable (4) from the top cover/keyboard. (The ngerprint reader cable is
attached to the top cover/keyboard with double-sided adhesive.)
5. Remove the ngerprint reader (5) and cable.
Reverse this procedure to install thengerprint reader.
78
Chapter 5Removal and replacement procedures for authorized service provider parts