9. If you need to replace remove the microphone board from the display, disconnect the cable from the
reverse ZIF connector on the board (1), and then use a tool (2) to release the board from the computer.
10. If you need to remove the hub board from the display:
a. Disconnect the display cable from the ZIF connector (1) on the hub board.
b. Disconnect the camera cable from the ZIF connector (2) on the hub board.
c. Disconnect the smaller cable from the reverse ZIF connector on the hub board (3).
d. Release the board from the display rear cover (4). You may need to use a tool.
The hub boards are available as spare part numbers N08541-001 and N08542-001.
Display assembly
67
To Next Page
Loading...
