11. If you need to remove the camera module:
▲ Lift up evenly across the module using a pry tool and peel the module up from the display back
cover (1), and then disconnect the cable from the reverse ZIF connector on the module (2). The
camera module is available as spare part numbers N09060-001 and N09061-001.
12. If you need to remove the display/camera cable, peel the cable o the inside of the display back cover
(1), remove the cable from the clips at the bottom of the display back cover (2), and then remove the
cable (3).
Display panel cables are available in the display panel kit, as the spare part number of N08558-001.
68
Chapter 6Removal and replacement procedures for authorized service provider parts
To Next Page
Loading...
