5. Connect the power cable (1) and data cable (2) to the rear of the hard drive.
NOTE: If the 3.5-inch hard drive is the primary drive, connect the other end of the data cable to the
dark blue SATA connector on the system board labeled SATA0. If it is a secondary hard drive, connect the
other end of the data cable to one of the light blue SATA connectors on the system board.
6. Reassemble the computer.
Hard drive cage
1. Prepare the computer for disassembly (Preparation for disassembly on page 20).
2. Remove the access panel (Access panel on page 21).
3. Rotate the drive cage to its upright position.
Drives 41
To Next Page
Loading...
