Hood lock
The hood lock is attached to the rear of the chassis.
1. Prepare the computer for disassembly (Preparation for disassembly on page 20).
2. Remove the access panel (Access panel on page 21).
3. On the rear of the computer, remove the security screw that secures the lock.
NOTE: The security screw requires a special security wrench to remove.
4. From the inside of the computer, disconnect the hood lock cable from the system board connector
labeled HLCK (1).
5. Lift the hood lock out of the computer (2).
To install the hood lock, reverse the removal procedure.
When installing the hood lock, on the inside rear of the computer, insert the clips on the back of the lock into
the slots on the computer rear panel, and then rotate the lock down into place.
58 Chapter 4 Removal and replacement procedures – small form factor (SFF) chassis
To Next Page
Loading...
