Hood sensor
The hood sensor is attached to the rear of the chassis.
1. Prepare the computer for disassembly (Preparation for disassembly on page 20).
2. Remove the access panel (Access panel on page 21).
3. Remove the air duct (Air duct on page 47).
4. Disconnect the hood sensor cable from the system board connector labeled HSENSE (1).
5. Slide the hood sensor out of the slot on the rear of the chassis (2). A tool such as a screwdriver may be
required to disengage the hood sensor from the slot.
To install the hood sensor, reverse the removal procedure.
Hood sensor 59
To Next Page
Loading...
