Speaker
The speaker is attached to the front of the rotating drive cage.
1. Prepare the computer for disassembly (Preparation for disassembly on page 20).
2. Remove the access panel (Access panel on page 21).
3. Remove the front bezel (Front bezel on page 21).
4. Rotate the hard drive cage to its upright position (Hard drive cage on page 41).
5. From the outside, front of the chassis, remove the two Torx T15 screws that secure the speaker.
6. From the inside of the chassis, disconnect the speaker cable from the white system board labeled SPKR
(1), and then slide the speaker to the right and remove it from the chassis (2).
To install the speaker, reverse the removal procedures. The following images shows the installation location
inside of the front of the computer.
62 Chapter 4 Removal and replacement procedures – small form factor (SFF) chassis
To Next Page
Loading...
