Option port board
For a list of available option port boards, see Boards, cards, and ports on page 9.
An option port board can be installed near the back of the system board that provides an additional connector
on the rear I/O panel.
NOTE: The image in this section shows an HDMI port expansion board.
To remove the option port board:
1. Prepare the computer for disassembly (Preparation for disassembly on page 20).
2. Remove the access panel (Access panel on page 21).
3. Remove the air duct (Air duct on page 47).
4. Remove the two Phillips screws (1) that secure the board to the system board.
5. Lift to disengage the board from the system board connector, and then remove the board from the
computer (2).
To install the option port board, reverse the removal procedures.
Option port board 57
To Next Page
Loading...
