Installing a 2.5-inch hard drive
1. Prepare the computer for disassembly (Preparation for disassembly on page 20).
2. Remove the access panel (Access panel on page 21).
3. Remove the front bezel (Front bezel on page 21).
4. Install four black-and-blue M3 mounting screws (two on each side of the drive).
NOTE: M3 metric mounting screws can be purchased from HP.
When replacing a drive, transfer the four mounting screws from the old drive to the new drive.
5. Rotate the hard drive cage to its upright position (Hard drive cage on page 41).
6. Align the mounting screws on the drive with the J-slots on the sides of the drive bay. Press the drive into
the drive bay, and then slide the drive forward until it locks in place.
Drives 43
To Next Page
Loading...
