Card reader
The card reader is attached to the front of the rotating drive cage.
1. Prepare the computer for disassembly (Preparation for disassembly on page 20).
2. Remove the access panel (Access panel on page 21).
3. Remove the front bezel (Front bezel on page 21).
4. Rotate the hard drive cage to its upright position (Hard drive cage on page 41).
5. From the inside of the chassis, disconnect the card reader cable from the white system board labeled SD
RDR.
6. Rotate the hard drive cage down to its normal position (Hard drive cage on page 41).
60 Chapter 4 Removal and replacement procedures – small form factor (SFF) chassis
To Next Page
Loading...
