7. Connect the power cable (1) and data cable (2) to the rear of the hard drive.
NOTE: If the 2.5-inch hard drive is the primary drive, connect the other end of the data cable to the
dark blue SATA connector on the system board labeled SATA0. If it is a secondary hard drive, connect the
other end of the data cable to one of the light blue SATA connectors on the system board.
8. Rotate the drive cage back down to its normal position.
IMPORTANT: Be careful not to pinch any cables or wires when rotating the drive cage down.
9. Reassemble the computer.
Removing and installing an M.2 SSD storage card
NOTE: The computer supports 2230 and 2280 M.2 SSD cards.
1. Prepare the computer for disassembly (Preparation for disassembly on page 20).
2. Remove the access panel (Access panel on page 21).
3. Remove the front bezel (Front bezel on page 21).
4. Rotate the hard drive cage to its upright position (Hard drive cage on page 41).
44 Chapter 4 Removal and replacement procedures – small form factor (SFF) chassis
To Next Page
Loading...
