HP EliteOne 1000 G2 - Enabling the monitor head detection warning; Installing a security cable

Enabling the monitor head detection warning
This warning is monitored if the monitor head cables are not fully connected. HP recommends ensuring that
this warning is enabled on systems with an installed monitor head.
1. Turn on or restart the computer, and when the HP logo appears, press f10 to enter Computer Setup.
2. Select Advanced, and then select Built-In Devices.
3. Select Allow No Panel conguration.
4. Select Main, and then Save Changes and Exit to save your settings.
Your changes take eect when the computer restarts.
Installing a security cable
A security cable is a key lock device that has a wire cable attached. Attach one end of the cable to your desk
(or other stationary object) and the other end of the cable to the security cable slot on the computer base
unit. Secure the security cable lock with the key.
Enabling the monitor head detection warning 9