HP EliteOne 1000 G2 - Locating internal components; Removing and installing memory; Memory module specifications

Locating internal components
Components
(1) Hard drive (3) RTC battery
(2) M.2 SSD (under the fan) (4) Memory modules
Removing and installing memory
The memory slots on the system board can be populated with up to two industry-standard small outline dual
inline memory modules (SODIMMs). These memory slots are populated with at least one preinstalled memory
module.
Memory module specications
For proper system operation, the memory modules must meet the following qualications:
Component Specication
Memory modules 1.2 volt DDR4-SDRAM memory modules
Compliance Unbuered non-ECC DDR4-2400 MHZ–compliant
Pins Industry-standard 260 pins containing the mandatory Joint Electronic Device
Engineering Council (JEDEC) specication
Support Support CAS latency DDR4 2400 MHz (15–15–15 timing)
Slots 2
Maximum Memory 16 GB per memory slot, 32 GB total
Supported 4 Gbit and 8 Gbit non-ECC memory technologies single-sided and double-sided SODIMMs
Note The system will not operate properly if you install unsupported SODIMM
memory. SODIMMs constructed with x8 and x16 DDR devices are supported; memory
modules constructed with x4 SDRAM are not supported.
HP oers upgrade memory for this computer and advises that the consumer purchase it to avoid
compatibility issues with unsupported third-party memory.
Locating internal components 21