HP EliteOne 1000 G2 - Setup; Installing the monitor head

2 Setup
Installing the monitor head
A monitor head can be installed in the standalone computer base. The monitor head can then be removed and
replaced with a dierent monitor.
1. Remove all removable media, such as USB ash drives, from the computer.
2. Turn o the computer properly through the operating system, and turn o any external devices.
3. Disconnect the power cord from the AC outlet and disconnect any external devices.
IMPORTANT: Regardless of the power-on state, voltage is always present on the system board as long
as the system is plugged into an active AC outlet. You must disconnect the power cord and wait
approximately 30 seconds for the power to drain to avoid damage to the internal components of the
computer.
4. To remove the rear access cover to access the monitor head installed in a dierent computer, press the
two release buttons on the rear of the base unit (1), and at the same time rotate the rear of the cover up
(2). Then, slide the cover back to remove it from the base (3).
Installing the monitor head 5