7. Lift the stand up (2), and then pull the stand hooks out of the computer (3).
Attaching and removing a adjustable-height stand
Attaching a adjustable-height stand
To install the stand:
1. Place the computer face down on a soft flat surface. HP recommends that you set down a blanket,
towel, or other soft cloth to protect the bezel and screen surface from scratches or other damage.
2. Engage the hooks in the top of the stand in the two large holes in the upper part of the back of the
computer (1).
3. Lower the stand onto the computer (2) and press down until it clicks into place (3).
Attaching and removing a stand 19
To Next Page
Loading...
