Inserting and removing a micro SIM or microSD card
CAUTION: To prevent damage to the connectors, use minimal force when inserting a micro SIM or microSD
card.
WARNING! HP recommends that HP Custom Integration Services (CIS), an authorized HP service provider, or
participants in the HP Self-Maintainer program perform insertion or removal of a micro SIM or microSD card.
Any damage caused by the customer removing the tablet from the jacket is not covered under the limited
warranty of the product. HP requires that HP Custom Integration Services (CIS), an authorized HP service
provider, or participants in the HP Self-Maintainer program perform future maintenance operations.
To insert or remove a micro SIM or microSD card, follow these steps:
NOTE: To see a video of how to remove and replace the tablet jacket, go to http://www.hp.com/go/sml.
1. Shut down the tablet.
2. Disconnect all external devices connected to the tablet.
3. Unplug the power cord from the AC outlet.
4. Remove the top four screws (1), and then remove the eight screws from the bottom and sides of the
jacket (2). Two of the bottom screws are inside the bottom I/O door.
16 Chapter 3 Connecting to a network
To Next Page
Loading...
Need help?
General
Weight and Dimensions
