HP Enterprise ProLiant MicroServer Gen10 User Manual

87 pages

To Next Page

To Previous Page

Install the expansion board

Prerequisites

Before you perform this procedure, make sure that you have T-15 Torx screwdriver available.

Procedure

Identify the expansion slot compatible with the expansion board, and then remove the blank opposite that slot.

Retain the blank for future use.

2. Verify that any switches or jumpers on the expansion board are set properly.

For more information, see the expansion board documentation.

3. Install the expansion board. Verify that the board is firmly seated in the slot.

Hardware options installation

Questions and Answers:

Need help?

Do you have a question about the HP Enterprise ProLiant MicroServer Gen10 and is the answer not in the manual?

General