To Next Page

To Previous Page

Cabling

Cabling overview

This section provides guidelines that help you make informed decisions about cabling the server and hardware options to

optimize performance.

CAUTION: When routing cables, always be sure that the cables are not in a position where they can be pinched or

crimped.

Four-bay non-hot-plug drive cabling

The four-bay non-hot-plug drive cable assembly consists of the drive power and SATA cables attached to a bracket. If

either the drive power or SATA cable becomes defective, the entire cable assembly will need to be replaced.

• LFF/SFF drive SATA cable connected to the system board

Item Description

1 P2 power supply cable

2 LFF/SFF drive power cable

3 LFF/SFF drive SATA cable

• LFF/SFF drive SATA cable connected to a Smart Array storage controller board

Cabling

Questions and Answers:

Need help?

Do you have a question about the HP Enterprise ProLiant MicroServer Gen10 and is the answer not in the manual?

HP Enterprise ProLiant MicroServer Gen10 Specifications

General