HP Enterprise ProLiant MicroServer Gen10 User Manual

87 pages

To Next Page

To Previous Page

Internal USB device options

The server has an internal USB 20 port that you can use to install an internal USB flash media device for:

• booting up from flash solution

• data backup/redundancy

Install an internal USB device

Procedure

Power down the server.

Disconnect the power cord from the AC source, and then from the server.

Disconnect all peripheral cables from the server.

Remove the chassis cover.

Plug in the USB device into the internal USB port.

Hardware options installation

Questions and Answers:

Need help?

Do you have a question about the HP Enterprise ProLiant MicroServer Gen10 and is the answer not in the manual?

General