Speakers (front)
Description Spare part number
Speaker Kit 812705-001
Before removing the speakers, follow these steps:
1. Turn o the computer. If you are unsure whether the computer is o or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect the power from the computer by unplugging the power cord from the computer.
3. Disconnect all external devices from the computer.
4. Remove the bottom cover (see Bottom cover on page 35).
5. Remove the battery (see Battery on page 54).
6. Remove the hard drive (see Hard drive on page 55).
Remove the speakers:
1. Remove the two broadhead Phillips PM2.0×2.0 screws (1) that secure the speaker to the computer.
NOTE: The speaker includes rubber isolators (2) around the screws. These isolators are crucial to the
performance of the speakers.
2. Remove the speaker cable from its routing path (3).
3. Remove the speaker (4).
4. Disconnect the speaker cable (1) from the system board.
Component replacement procedures 57
To Next Page
Loading...
