HP HP-UX 11i v3

3. Verify that the VLANs with IDs 333 and 334 are tagged correctly. Enter:
Switch 1# show vlan 333
Status and Counters - VLAN Information - Ports - VLAN 333
802.1Q VLAN ID : 333
Name : vlan_333
Status : Port-based
Voice : No
Port Information Mode Unknown VLAN Status
---------------- -------- ------------ ----------
Trk4 Tagged Learn Up
Switch 1# show vlan 334
Status and Counters - VLAN Information - Ports - VLAN 334
802.1Q VLAN ID : 334
Name : vlan_334
Status : Port-based
Voice : No
Port Information Mode Unknown VLAN Status
---------------- -------- ------------ ----------
Trk4 Tagged Learn Up
To create the VLANs on Switch 2, complete the following steps:
1. Create the VLANs with IDs 333 and 334. Enter:
Switch 2#
Switch 2# configure
Switch 2(config)# vlan 333 name vlan_333
Switch 2(config)# vlan 334 name vlan_334
2. Tag ports F17 and F18 to VLANs 333 and 334. Enter:
Switch 2(config)# vlan 333 tagged F17
Switch 2(config)# vlan 333 tagged F18
Switch 2(config)# vlan 334 tagged F17
Switch 2(config)# vlan 334 tagged F18
Switch 2(config)# exit
3. Verify that the VLANs with IDs 333 and 224 are tagged correctly. Enter:
Switch 2# show vlan 333
Status and Counters - VLAN Information - Ports - VLAN 333
802.1Q VLAN ID : 333
Name : vlan_333
Status : Port-based
Voice : No
Port Information Mode Unknown VLAN Status
---------------- -------- ------------ ----------
F17 Tagged Learn Up
F18 Tagged Learn Up
Switch 2# show vlan 334
Status and Counters - VLAN Information - Ports - VLAN 334
802.1Q VLAN ID : 334
Name : vlan_334
Status : Port-based
Voice : No
Port Information Mode Unknown VLAN Status
---------------- -------- ------------ ----------
F17 Tagged Learn Up
F18 Tagged Learn Up
108 VLANs over APA using HP Procurve switches