Remote Insight Command Language 323
WARM_BOOT_SERVER
This WARM_BOOT_SERVER command is used to warm boot a server. For this
command to parse correctly, the WARM_BOOT_SERVER command must
appear within a SERVER_INFO command block, and SERVER_INFO MODE
must be set to write. The user must have the virtual power and reset privilege to
execute this command.
Example:
<RIBCL VERSION="2.0">
<LOGIN USER_LOGIN="adminname" PASSWORD="password">
<SERVER_INFO MODE="write">
<WARM_BOOT_SERVER/>
</SERVER_INFO>
</LOGIN>
</RIBCL>
WARM_BOOT_SERVER Parameters
There are no parameters for this command.
WARM_BOOT_SERVER Runtime Errors
The possible error messages include:
•
•
•
Server information is open for read-only access. Write access is required for
this operation.
Host power is already OFF.
User does not have correct privilege for action. RESET_SERVER_PRIV
required.
GET_UID_STATUS
The UID_STATUS command requests the state of the server UID. For this
command to parse correctly, the UID_STATUS command must appear within a
SERVER_INFO command block, and SEVER_INFO MODE can be set to read
or write.
To Next Page
Loading...
