68 User Guide Integrated Lights-Out
3. Click Connect.
To use an image file:
1. Select Local Image File within the Virtual Floppy section of the Virtual
Media applet.
2. Enter the name of the diskette image in the text box. You can also click
Browse to locate image files.
3. Click Connect.
When connected, the virtual devices are available to the host server until you
close the Virtual Media applet. When you are finished using the Virtual Floppy,
you can either select to disconnect the device from the host server or close the
applet.
NOTE: The Virtual Media applet must remain open in your browser as
long as you continue to use a Virtual Media Device.
The iLO Virtual Media floppy are available to the host server at run time if the
operating system on the host server supports USB floppy drives. Refer to
"Operating System USB Support (on page 65
)" for information on which
operating systems support USB mass storage at the time of the publication of this
manual.
To Next Page
Loading...
