HP J8697A User Manual

2-7
Configuring Username and Password Security
Configuring Local Password Security
To Remove Password Protection. Removing password protection means
to eliminate password security. This command prompts you to verify that you
want to remove one or both passwords, then clears the indicated password(s).
(This command also clears the username associated with a password you are
removing.) For example, to remove the Operator password (and username, if
assigned) from the switch, you would do the following:
Figure 2-3. Removing a Password and Associated Username from the Switch
The effect of executing the command in figure 2-3 is to remove password
protection from the Operator level. (This means that anyone who can access
the switch console can gain Operator access without having to enter a user-
name or password.)
If you want to remove both operator and manager password protection, use
the no password all command.
Username and Password Length.
The limit on username and password length is 64 characters for the following
authentication methods:
■ Front-end—WEB User Interface, SSH, and Telnet
■ Back-end—RADIUS, TACACS+, and Local
General Rules for Usernames and Passwords
Usernames and passwords are case-sensitive. ASCII characters in the range
of 33-126 are valid, including:
■ A through Z uppercase characters
■ a through z lower case characters
■ 0 through 9 numeric characters
■ Special characters ‘ ~ ! @ # $ % ^ & * ( ) - _ = + [ ] { } \ | ; : ‘ “ , < > / ?
(see Restrictions, below)
HP Switch(config)# no password
Password protection will be deleted, do you want to continue [y/n]? y
HP Switch(config)#
Press [Y] (for yes) and press [Enter].

HP J8697A Specifications

General

Ports	24
Form Factor	Rack-mountable
Power Supply	Internal
Management	Managed
VLAN Support	Yes
Jumbo Frame Support	Yes
Switching Capacity	48 Gbps
Forwarding Rate	35.7 Mpps
Model	HP J8697A
Port Type	10/100/1000BASE-T
Layer	Layer 2