HP Jetdirect 610N - HP Jetdirect EIO Menu

A-29
ENWW
HP Jetdirect EIO Menu
If your HP EIO printer or multifunction periperhal (MFP) device
has a control panel, you can configure basic network parameters
through the Jetdirect EIO menu on the printer’s control panel.
Printers with control panel support include:
● HP LaserJet 4000, 4050, 4100, 5000, 8000, 8100, 8150, 9000
Series EIO printers and MFPs
● HP Color LaserJet 4500, 4550, 8500, 8550 Series EIO printers
and MFPs
● HP Business InkJet 2200/2250 Series EIO printers
● HP DesignJet EIO printers
Note To configure HP Jetdirect parameters on
HP DesignJet printers through the printer’s front
control panel, see your HP DesignJet setup guide.
For printers without control panels (for example,
HP LaserJet 2200 Series EIO printers), you must
use HP software or other tools for configuration.
You can use the printer control panel to do the following:
● Enable or disable network protocols (TCP/IP, IPX/SPX,
DLC/LLC, AppleTalk)
● Configure TCP/IP parameters
● Configure IPX frame types
● Configure IPX source routing for Token Ring networks
● Configure Apple EtherTalk Phase parameters for Ethernet
networks (600N only)
● Configure 10/100Base-TX link operation (610N/615N only)
The keystrokes to access the Jetdirect EIO menu from the printer
control panel depends on the printer. Refer to the printer manuals
for instructions to navigate the printer control panel.
The HP Jetdirect internal print servers support the following
printer control panels:
●
Classic Control Panel display with menu and parameter selection
buttons
●
Graphical Control Panel display with navigation and numeric
keypads (available on newer HP LaserJet printer models)