HP Jetdirect 610N - Configuring Apple Ethertalk Phase Parameters (600 N Ethernet Cards Only

A-35
ENWW
Configuring Apple EtherTalk Phase Parameters
(600N Ethernet Cards Only)
Note For HP J6057A 615N or J4169A 610N print servers,
the AppleTalk phase parameter is set to phase 2 and
is not configurable.
You can configure Apple EtherTalk parameters if the Apple
EtherTalk protocol is enabled, and the PostScript printer language
is enabled.
To ensure the PostScript printer language is enabled, check the
printer’s configuration. The printer personality should be set to
PostScript or Auto.