18 Using Quick setup
Wireless communities
The M210 allows you to create up to four wireless communities. Each wireless community
defines the settings for a distinct wireless network, with its own network name (SSID), settings
for wireless protection, user authentication, VLANs, and more. Radio settings are shared by all
wireless communities.
If you selected the Basic wireless network environment, you cannot configure additional
wireless communities on the Quick setup page—this configuration assumes that only one
wireless network is needed. You can later configure additional communities on the Wireless >
Communities page.
A default wireless community is defined on the M210. Its name (or SSID) is HP and it is
assigned to VLAN 1. The settings that initially display in the Wireless community settings
pertain to the default community.
Note Before creating a new community, ensure that the name (SSID), VLAN, and security settings for
the default community are configured as needed.
To create a new community:
1. S e l e c t Add New Wireless Community.
An additional row displays in the wireless community table. The fields in the Wireless
community settings area display default values for the new community.
2. Modify the default values, if necessary. See Wireless community settings for a description
of these fields.
3. Select Add.
4. Select Save to accept the default settings in the Wireless community settings area,
or modify the settings and select Add, then Save.
If you select Cancel before selecting Add, the new wireless community will be deleted.
If you change these settings after saving a new wireless community, select Update, then
Save. You can select Cancel before selecting Update to undo any changes to these
settings.
Wireless community settings
These settings apply to the default wireless community or, if you have created multiple
communities, the wireless community selected in the table. After you select Save, you can use
the Wireless > Communities page if you want to update these settings.
Identify the wireless network
Use this section to define a name for the wireless community.
Network name (SSID)
Specify a name to uniquely identify the wireless network associated with this community. Each
wireless user that wants to connect to this community must use the network name.
By default, the M210 will broadcast this name so that wireless users can see it when they try to
connect to the wireless network.
To Next Page
Loading...
Need help?
General
