7. Remove the four Torx screws (1) that secure the top cover to the computer.
8. Make sure the wireless cables (2) and display panel cable (3) feed cleanly through the openings.
9. Remove the top cover (4) from the display assembly.
10. If it is necessary to replace the display bezel or any of the LED display assembly
subcomponents:
a. Flex the inside edges of the top edge (1), the left and right sides (2), and the
bottom edge (3) of the display bezel until the bezel disengages from the display enclosure.
b. Remove the display bezel (4).
60 Chapter 6 Removal and replacement procedures for Authorized Service Provider parts
To Next Page
Loading...
