11. If it is necessary to replace the display panel:
a. Remove the four Phillips screws (1) that secure the display panel to the display enclosure.
CAUTION: Before turning the display panel upside down, make sure the work surface is
clear of tools, screws, and any other foreign objects. Failure to follow this caution can result
in damage to the display panel.
b. Lift the top edge of the display panel (2).
c. Swing the display panel (1) up and forward until it rests upside down in front of the display
back cover.
d. Release the adhesive strip (2) that secures the display panel cable connector to the
display panel.
e. Remove the display panel (3).
Component replacement procedures 61
To Next Page
Loading...
