Troubleshooting
Maintenance and Service Guide 2–3
3. To exit Computer Setup, choose one of the following
methods:
❏ To exit Computer Setup without saving your preferences,
use the arrow keys to select File > Ignore Changes and
Exit. Then follow the instructions on the screen.
❏ To save your preferences and exit Computer Setup, use the
arrow keys to select File > Save Changes and Exit. Then
follow the instructions on the screen.
Your preferences go into effect when the computer restarts.
Restoring Factory Settings in Computer
Setup
To return all settings in Computer Setup to the values that were
set at the factory, follow these steps:
1. Open Computer Setup by turning on or restarting the
computer, and then pressing
f10 while the “F10 = ROM
Based Setup” message is displayed in the lower-left corner of
the screen.
2. Use the arrow keys to select File > Restore defaults, and
then press
enter.
3. When the confirmation dialog box opens, press
f10.
4. To save your preferences and exit Computer Setup, use the
arrow keys to select File > Save Changes and Exit. Then
follow the instructions on the screen.
Your preferences go into effect when the computer restarts.
✎
Your password settings and security settings are not changed
when you restore the factory settings.
To Next Page
Loading...
Need help?
General
