3–8 Getting Started
Next Steps
Enable Communication Hardware
Your modem is enabled when the modem cable is
connected
to the notebook and to an analog telephone line.
■ If you connected the modem cable during hardware setup,
your modem is enabled. Proceed to
“Set Up Internet Service”
next in this chapter.
■ If you did not connect the modem cable during hardware
setup:
a. Turn off your notebook.
b. Follow the instructions in the “Step 3: Connect the
Modem” section of Chapter 1, “Hardware Setup.”
c. Start your notebook in Windows.
d. Then proceed to “Set Up Internet Service” next in this
chapter.
For information about setting up a wireless device, visit
http://www.hp.com/go/wireless.
For more information about modem, wireless, cable,
DSL
(Digital Subscriber Line) and network connections,
select
Start > Help and Support. The Help and Support utility
provides hardware and software information, instructions,
tutorials, and wizards that can help you set up or troubleshoot
a
variety of connections.
Set Up Internet Service
You must set up Internet service before you can connect to the
Internet. HP has made arrangements with leading ISPs in many
locations to help you set up a new Internet account or to configure
your notebook to use an existing account.
Depending on your location, you might be able to set up
Internet
service by using the Easy Internet Sign-up utility
or
an ISP-provided icon on your desktop.
In all locations, you can set up Internet service by using
the
Windows Internet Connection wizard.
To Next Page
Loading...
Need help?
General
