Select To do this
Intel ME Firmware Local Update Disable/enable local management of firmware updates.
LAN Controller Disable/enable the integrated network controller.
Intel ME Features Control Disable/enable AMT or none.
Intel ME Power Control Configure the management engine power policies.
iAMT Configuration
Select To do this
Host Name Assign a host name to the computer.
TCP/IP Disable/enable network interface or DHCP (assigns an IP
address if DHCP has been disabled) or change the domain
name.
Provision Model Assign Enterprise or Small Business iAMT model.
Setup and Configuration Set options to control remote configuration of AMT.
Un-Provision Reset the AMT configuration to factory defaults.
SOL/IDE-R Disable/enable remote boot control to IDE diskette or CD-ROM
and assign a user name and password.
Password Policy Set options to control requirements for the network password
and the MEBx password.
Secure Firmware Update Disable/enable or disable updating firmware remotely.
Set PRTC Set the real-time clock.
Idle Timeout Set a time-out value.
Change Intel ME Password
Select To do this
Change ME Password Change the password.
NOTE: The default password is admin.
Using the HP Universal Print Driver (select models only)
The HP Universal Print Driver Series for Windows is a single intelligent driver that replaces individual
drivers for HP networked printers.
NOTE: The HP Universal Print Driver is preinstalled on select computer models only. To download
the HP Universal Print Driver or obtain more information about using it, see the HP Web site at
http://www.hp.com/go/universalprintdriver (English only).
Using the HP Universal Print Driver (select models only) 77
To Next Page
Loading...
Need help?
General
