150
Software Fixes in Release K.11.12 - K.13.49
Release K.11.33
■ Module (PR_1000330312) — Booting up the Switch with an unsupported module installed
may cause all existing modules to fail.
■ MSTP Enhancement (PR_1000331792) — Implementation of Spanning-tree BPDU Filter
and SNMP Traps.
■ Power Supply (PR_1000310159) — After power supply failovers, the Switch incorrectly
reports power being available on ports that are actually powered down.
■ QoS/Rate Limiting (PR_1000319946) — QoS/Rate limiting may stop working or impact
unwanted traffic streams.
■ QOS (PR_1000325028) — Switch may crash after configuring QOS device-priority.
■ SNMPv3 (PR_1000325021) — SNMPv3 lines may mistakenly be removed from the
configuration file.
■ STP (PR_1000333992) — In a redundant STP network with PIM running, PIM packets may
get assigned a higher queue priority than STP packets, which may cause network loops.
■ Switch (PR_1000327506) — Fixed issue where Switch incorrectly allowed jumbos frames
to be configured for 10/100 ports.
■ VLAN (PR_1000334107) — User is unable to add a port to a VLAN and the Switch responds
with an invalid error message.
■ Web UI (PR_1000308213) — Removed Web Stacking Tab within the Web User Interface
for the 5400zl products.
■ Web UI (PR_1000308225) — When using the Web User Interface, the device view of the
Stack Close-up is missing.
■ Web UI (PR_1000311087) — Serial number for 5400zl products within the Web-UI exceeds
the provided rectangle.
■ Web UI (PR_1000322777) — When using the Web User Interface in the Configuration Tab,
a user is unable to modify a port name.
■ Web UI (PR_1000329279) — When using the Web user interface Commander's Stack Close
Up view, some stack members are not displayed.
Release K.11.33
The following problems were resolved in release K.11.33
■ Buffer Leak (PR_1000336963) — The Switch may run out of packet buffers under certain
conditions.
■ Crash/ACL (PR_1000337717) — The Switch may crash with a message similar to:
To Next Page
Loading...
