HP ProCurve 3500yl - Release K.13.05

186
Software Fixes in Release K.11.12 - K.13.49
Release K.13.05
Release K.13.05
The following problems were resolved in release K.13.05 (not a public release).
■ Link/Config (PR_1000771549) — On a ProCurve 3500yl Series Switch, a link will not come
up after configuring the port mode from MDI to AUTOMDIX (on one side of the link).
■ Static Route/Config (PR_1000785177) — The VLAN ID for the static route configuration
is changed from its original value after updating from K.12.xx to K.13.03.
■ SNMP/Config (PR_1000780506) — The TFTP transfer of a config file to the switch will
fail if the config file contains the command snmp-server trap-source <xx.xx.xx.xx>.
■ Crash (PR_0000000971) — Following MAC authentication of a number of users that have
a RADIUS ACL, priority, and a number of other parameters applied, the switch may crash
with a message similar to:
NMI event SW:IP=0x00334dc8 MSR:0x00029210 LR:0x00334e3c Task='mWeb-
Auth' Task ID=0x8413770. cr: 0x20004044 sp:0x08413260 xer:0x20000000
■ Crash (PR_1000783817) — The switch may crash with a message similar to:
NMI event SW:IP=0x0010770c MSR:0x00029210 LR:0x00107714
Task='midmCtrl' Task ID=0x8417f00 cr: 0x24004084 sp:0x08417c08
xer:0x00000000
■ SNMP/Config (PR_1000786158) — The TFTP transfer of a configuration file created on
K.12.xx to a switch running K.13.03 will fail if the configuration file contains the command
snmp-server enable traps authentication.
■ IPv6/Config (PR_1000781026) — When a configuration file is transferred to the switch
and the file contains a VLAN with the ‘ipv6 mld’ statement, the switch alters the ‘ipv6
mld’ statement to ‘no ipv6 mld fastleave
1-A24,=1-Mesh,Trk1-Trk60,Dyn1-Dyn60’.
■ SNTP/Config (PR_1000786156) — The TFTP transfer of a configuration file created on
K.12.xx to a switch running K.13.03 will fail if the configuration file contains the command
sntp server <x.x.x.x>.
■ VLAN/Config (PR_1000782308) — Updating from K.12.xx to K.13.03 may result in an
incorrect port VLAN assignment.
■ Telnet-Server/Config (PR_0000000946) — The TFTP transfer of a config file to the
switch will fail if the config file contains the command no telnet-server.
■ Authorized-Manager/Config (PR_1000789930) — The update from K.12.xx to K.13.03
does not translate the IP authorized-manager configuration properly.