HP ProCurve 3500yl - DNS Capabilities for Telnet

89
Enhancements
Release K.13.04 Enhancements
Figure 3. Example of Disabling Inbound Multicast Rate-limiting for Port 3
Operating Notes
• This rate-limiting feature does not limit unicast traffic.
• This feature does not include outbound multicast rate-limiting.
For more detailed information about rate-limiting, see the Multicast and Routing Guide for your
switch.
■ Enhancement (PR_ 0000000087) — This enhancement enables a Telnet client to use the
histamine in command input.
DNS Capabilities for Telnet
Overview
This enhancement enables a Telnet client to use the hostname in command input.
Syntax: telnet <ipv4-addr | ipv6-addr | hostname | switch-num>
Initiates an outbound telnet session to another network device. The destination can
be specified as:
• IPv4 address
• IPv6 address
•Hostname
• Stack number of a member switch (1-16) if the switch is a commander
in a stack and stacking is enabled
ProCurve(eth-3)# no rate-limit mcast in
ProCurve(eth-3)# show rate-limit mcast
Multicast-Traffic Rate Limit Maximum %
Port | Inbound Limit Mode Radius Override
----- + ------------- --------- ---------------
1 | Disabled Disabled No-override
2 | Disabled Disabled No-override
3 | Disabled Disabled No-override
4 | Disabled Disabled No-override