HP ProCurve 3500yl

To Next Page

To Previous Page

Enhancements

Release K.13.04 Enhancements

Figure 1. Example of Inbound Broadcast Rate-limiting of 50% on Port 3

If you rate-limit multicast traffic on the same port, the multicast limit is also in effect for that port,

as shown in Figure 2. Only 20 percent of the multicast traffic will be forwarded.

Figure 2. Example of Inbound Multicast Rate-limiting of 20% on Port 3

To disable rate-limiting for a port enter the no form of the command.

ProCurve(config)# int 3

ProCurve(eth-3)# rate-limit bcast in percent 50

ProCurve 3500(eth-3)# show rate-limit bcast

Broadcast-Traffic Rate Limit Maximum %

Port | Inbound Limit Mode Radius Override

----- + ------------- --------- ---------------

1 | Disabled Disabled No-override

2 | Disabled Disabled No-override

3 | 50 % No-override

4 | Disabled Disabled No-override

5 | Disabled Disabled No-override

ProCurve(eth-3)# rate-limit mcast in percent 20

ProCurve(eth-3)# show rate-limit mcast

Multicast-Traffic Rate Limit Maximum %

Port | Inbound Limit Mode Radius Override

----- + ------------- --------- ---------------

1 | Disabled Disabled No-override

2 | Disabled Disabled No-override

3 | 20 % No-override

4 | Disabled Disabled No-override

HP ProCurve 3500yl - Page 99