182
Software Fixes in Release K.11.12 - K.13.49
Release K.13.03
■ CLI (PR_1000455370) — Commands that display portmaps may yield corrupted
output. For example, a single port may be displayed as a port range.
■ RIP (PR_1000751858) — Some static routes may not be correctly distributed by RIPv1 or
RIPv2.
■ PIM (PR_1000714322) — A new multicast stream may not get forwarded by the switch.
■ Crash (PR_1000759046) — Using the "\" character with or without other character
combinations may cause the switch to crash with a message similar to the following. There
may also be different crash messages resulting from the same problem.
Software exception at parser.c:2653 — in 'mSess1', task ID =
0x898e6a0-> ASSERT: failed
■ PIM (PR_1000749627) — A switch with PIM-SM may send a prune to the RP when none
is required.
■ Web Management (PR_1000472572) — The Web Management Interface does not
properly allow configuration of port monitoring/mirroring.
Addendum to Release K.13.02:
■ ACL (PR_1000714376/1000760152) — Attempts to apply an access group to a range of
ports will fail after the initial configuration unless a write mem and reload are done in
between configuration statements.
Release K.13.03
The following problems were resolved in release K.13.03.
■ Enhancement (PR_1000400991) — The 802.1X Controlled Directions feature now
functions independently of the STP configuration. For more information, see “Release
K.13.03 Enhancements” on page 75.
■ IPv6 (PR_1000768670) — When virus throttling is configured on a port that belongs to an
IPv6 enabled VLAN, some IPv6 all nodes (ff02::1) multicast traffic may be dropped.
■ Mirroring (PR_1000768655) — After a mirror ACL has been modified, some ACL
commands that follow may result in an unresponsive CLI session.
■ IDM ACL (PR_1000768727) — An IDM ACL that uses the syntax, destination ip "any"
will result in a parsing error, the ACL will not be applied, and the client authentication will
fail. Workaround: Instead of the term "any," use “0.0.0.0/0.”
■ VRRP PDT (PR_1000756475) — If the VRRP preemptive delay timer (PDT) is configured,
the virtual router mode (Owner or Backup) cannot be changed unless the PDT configuration
is removed.
To Next Page
Loading...
