192
Software Fixes in Release K.11.12 - K.13.49
Release K.13.13
.iso.org.dod.internet.mgmt.mib-
2.entityMIB.entityMIBObjects.entityPhysical.entPhysicalTable.entPhys
calEntry.entPhysicalSerialNum
.iso.org.dod.internet.mgmt.mib-
2.entityMIB.entityMIBObjects.entityPhysical.entPhysicalTable.entPhys
calEntry.entPhysicalModelName
Release K.13.13
The following problems were resolved in release K.13.13 (never released).
■ 802.1X (PR_1000446227) — Switch 802.1X authentication running over PAP does not
work if the RADIUS message authenticator attribute is required. This fix added the message
authenticator attribute to non-EAP RADIUS responses.
■ VLAN/MSTP (PR_0000002103) — The alteration of the VLAN/MSTP instance mapping in
the pending configuration is not properly functioning. Any attempt to remove a single VLAN
ID (VID) from one MSTP instance and then assign it to another MSTP instance fails, though
specifying a VID range succeeds.
■ SSH (PR_0000001296) — Upon reboot, if no key is present, a 1024-bit dsa ssh host key is
installed rather than the previous default host key type of a 2048-bit rsa key.
■ CLI (PR_1000430534) — Output from the show port-access mac-based CLI command may
omit connected clients.
■ Static Routes/Config (0000001461) — Static routes mapped to VLANs are incorrectly
migrated during the update from K.12.xx to K.13.xx. This is a further improvement to the fix
originally implemented in K.13.10.
■ DHCP (PR_0000002888) — A client may not be able to get a DHCP address when the
Management VLAN is configured on the switch.
Release K.13.14
The following problems were resolved in release K.13.14 (not a public release).
■ OSPF (PR_0000003395) — If a transceiver or mini-GBIC is inserted (hotswapped) on a
port that is a member of a VLAN configured for jumbo frames and OSPF, the OSPF state
stops at EXCHANGE and EXSTART.
To Next Page
Loading...
