2-16
Installing the 5400zl Switches
Installation Procedures
Installing the 5400zl
Switches
Figure 2-6. Attaching Brackets to the 5400zl Switch
2. Partially install a screw into the top hole of a pair of holes that are 0.5
inches apart in each rack/cabinet upright as shown in the illustration
below. Ensure that the screws are at the same level in each upright.
Figure 2-7. Mounting Screw Positioning
Partially install a screw
into the top hole of a
close (0.5-inch) pair on
both sides of the rack
To Next Page
Loading...
Need help?
General