Power supply
Follow these steps to remove the power supply:
1. Prepare the computer for disassembly (see Preparation for disassembly on page 31).
2. Remove the access panel (see Access panel on page 32).
3. Remove the front bezel (see Front bezel on page 34).
4. Remove the drive cage (see Drive cage on page 35).
Remove the power supply:
1. Position the computer with the rear panel toward you.
2. Disconnect the power supply P1 (1), P2 (2), and P3 (3)cables from the system board.
3. Release the power supply P3 cable from the retention clips built into the fan shroud (4).
4. Remove the four Torx-15 M3.0×9.0 screws (5)that secure the power supply to the computer chassis.
5. Press down on the power supply release tab (6).
6. Slide the power supply forward (7), and then remove the power supply.
Reverse this procedure to install the power supply.
42 Chapter 4 Removal and replacement procedures
To Next Page
Loading...
