Processor
NOTE: The processor spare park kit includes replacement thermal material.
Follow these steps to remove the fan-sink:
1. Prepare the computer for disassembly (see Preparation for disassembly on page 31), and then remove the
following components:
2. Remove the access panel (see Access panel on page 32), and then remove the following components:
a. Front bezel (see Front bezel on page 34)
b. Drive cage (see Drive cage on page 35)
c. Shroud (see Fan shroud on page 43)
d. Fan-sink (see Fan-sink on page 44)
Remove the processor:
1. Depress the processor release lever (1), and then slide the lever to the right until it clears the locking clip.
2. Swing the processor release lever (2)up and back as far as it will go.
3. Swing the processor retention bracket (3)up and back as far as it will go.
Processor 45
To Next Page
Loading...
