Serial connector module
Follow these steps to remove the serial connector module:
1. Prepare the computer for disassembly (see Preparation for disassembly on page 31).
2. Remove the access panel (see Access panel on page 32), and then remove the following components:
a. Front bezel (see Front bezel on page 34)
b. Drive cage (see Drive cage on page 35)
c. Shroud (see Fan shroud on page 43)
Remove the serial connector module:
1. Disconnect the serial connector module cable (1)from the system board.
2. Remove the two 3/16-in. screw locks (2)that secure the serial connector module to the computer chassis.
3. Remove the serial connector module (3).
Reverse this procedure to install the serial connector module.
Serial connector module 47
To Next Page
Loading...
