Removal and replacement procedures 39
5. Do one of the following:
o Extend the server from the rack (on page 28).
o Remove the server from the rack (on page 30).
6. Remove the access panel ("Access panel" on page 37).
7. If an expansion board is installed in the primary PCI riser cage, then remove the PCI riser cage
("Remove the PCI riser cages" on page 31).
8. Remove the air baffle (on page 32).
9. Remove the fan cage (on page 33).
10. Prepare the non-hot-plug drive cable assembly for removal:
a. Disconnect the Mini-SAS and drive power cables from the system board.
b. Release the Mini-SAS and drive power cables from the front chassis cable clips.
— 4-bay LFF non-hot-plug drive cable disconnections
— 8-bay LFF non-hot-plug drive cable disconnections
To Next Page
Loading...
